BetaFPV 2S Brushless F4 FC Stack w/ 12A 4in1 ESC - XT30

$45.99
In Stock
Pre Order
Coming Soon
Add to Wishlist

The 2S ESC board is updated from 10A to 12A. Supports 2-3S now.

Note: Right now there are no 3S battery suitable for Beta75X frame. A customized 3S battery will be launched soon.

This F4 flight controller and ESC are customized for the 2S whoop drones   Beta65X and Beta75X. It will turn the brushless whoop drone into a beast.

    SPECIFICATIONS OF FC

    • CPU: STM32F405 (Overclock to 240MHz)
    • Six-Axis: MPU6000
    • Size: 26mm x 26mm, whoop mounting pattern
    • Firmware version: Betaflight OMNIBUSF4SD (OBSD)
    • OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
    • TX02、RX02 ports are available, so that it could support TBS micro receiver
    • RSSI ports is available
    • Buzzer solder pads
    • Support programmable LED like WS2812 etc
    • Weight: 2.7g
                 

            


    CONNECTION BETWEEN FC & CAM

                  SPECIFICATIONS OF ESC

                  • Support BLheli/BLHELI_S suite Pass-through ready
                  • Support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
                  • Input voltage: 2S-3S lipo
                  • Continue current: 12A
                  • Peak current: 18A 
                  • Firmware: BLHELI_S
                  • Processor: SILABS EFM8BB21F16G
                  • Motor Connectors: 1.5mm header pins connector

                           

                         

                  HOW TO ASSEMBLE FC & ESC

                  Note: Please assemble the FC and the ESC as the picture shown below, otherwise the fc will be BURNT to damage.

                            RECOMMENDED RECEIVER CONNECTION

                            All the ports are available on this board. So that you could connect any receiver you want on the board. For example.

                            • Frsky XM/XM+ Receiver
                            • TBS receiver
                            • DSMX receiver

                            For the details about how to connect the receiver and configure in Betaflight, please check the F4 2S Brushless FC & ESC Manual.

                              PACKAGE

                              • 1 * F4 2S brushless flight controller
                              • 1 * 4in1 12A ESC board
                              • 4 * M1.2x4mm screws
                              • 4 * M1.4x5mm screws
                              • 4 * Anti-vibration ruber dampers

                              You recently viewed

                              Clear recently viewed
                              x