Diatone v8.3 Filtered Power Distribution Board (PDB) with 5v and 12v Power Output - PDB
These things rock. Seriously they're really good. It filters your power for better video quality, has a super clean layout, 5V & 12V output so you don't need other filters, and can accept your ESC wire to make for a very clean build.
V8.3 Power HUB based on V7.3 changed the ESC solder tabs direction to make the ESC and battery solder pad be 90 degree, more suitable for X-type multirotor. The both-sides soldering way also suit H-type multirotor and no need to dismount the upper board, quite convenient to solder. 36X36mm size is easy to connect to flight controller. 4-layers PCB guarantees the 20A ESC’s steady working. 2 sets BEC circuit meanwhile can use servos, video transmitters, LEDs, moreover, V8.3 added the ESC signal channel, easy soldering and neat wiring. Support 3-6S (11.1V-22.2V). The HUB also features convenient solder bridge of various voltage for camera & video transmitter.
The new LC filter circuit uses superior filter inductor and 47uf tantalum capacitor, 1A electrical load 5V ripple just only 31mV, 12V ripple just only 63mV, camera and video transmitter gain purer power source.
Both-sides soldering ESC, convenient to use
2oz copper & 4-layers PCB
Low Ripple current
ESC & Battery solder tabs in pairs.
Solder Bridges of various voltage for Camera & VTX.
DC/DC synchronous buck regulator, Efficiency is up to 95%.
5V & 12V Output LED indicators & Short circuit tolerant.
Working Voltage: 3~6S LiPo (11.1-22.2V)
Output Voltage: 5V&12V
Output Current: 2A
ESC outputs: 4
Mounting: 30.5mm / Φ3mm
1 x Diatone V8.3 PDB
1 x Cable
Video - Quad With This PDB
We Also Recommend