HappyModel CrazyBee X DXS F4 1-2S AIO Whoop Flight Controller (F4 FC / 5A 4in1 ESC / 25mW VTX) - DSMX

$52.00
Coming Soon
In Stock
Pre Order
Free Delivery on U.S.A. Orders $60 or more
Add to Wishlist

Flight controller, 4in1 ESC, VTX, and an RX all in one board. Just plug in your favorite camera and motors.

Be sure to check out all our Whoop FCs and our HappyModel gear collection!

Specifications

F4 Flight Controller

  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
  • Sensor: MPU-6000(SPI connection)
  • Board size: 28.5 * 28.5MM
  • Power supply: 1S-2S battery input (DC 2.9V-8.7V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G VTX
  • Built-in SPI Frsky receiver support D8/D16
  • Built-in 5V 1A BEC
  • Built-in voltage detection
  • Firmware target: CRAZYBEEF4FR

Onboard 5A BL_S 4in1 ESC

  • Power supply: 1-2S LiPo/LiPo HV
  • Current: 5A continuous peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: S_H_90_REV16_7.HEX
  • Default protocol: DSHOT600

Onboard DSM2/DSMX SPI receiver

  • SPI BUS receiver DSM2/DSMX compatible
  • Channels: Max 12ch
  • Failsafe support
  • No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m
  • RSSI enable(show on the goggles)

    Onboard 5.8G 40CH 25mW VTX

    • Output power: 25mw
    • Frequency: 40CH
    • Input voltage: 3.3V 5.5V
    • Current consumption: 300mA(type)
    • Frequency: 5.8GHz 5bands 40 channels
    • With Race band
    • Smartaudio ready
    • Default vtx_power should set to be “2”

    Onboard Voltage and Current detector

    • Voltage Meter scale “110”
    • Amperage Mete scale “1175”

    Includes

    • 1x HappyModel CrazyBeeX DXS F4 AIO Whoop Flight Controller (F4 FC, 5A 1-2S 4in1 ESC, 25mW VTX) - DSMX

    Bind procedure:

    1. Plug the USB then press the bind button, the red LED at the bottom of the flight controller will blinking fast , this indicate the SPI DSM2/DSMX receiver is in bind mode.
    2. Plug the USB then connect to Betaflight configurator, move to the CLI tab , then type “bind_rx”, the red LED at the bottom of the flight controller will blinking fast too , this indicate the SPI DSM2/DSMX receiver is in bind mode.

     

    x