Cart 0

Matek F405 FC Flight Controller - F4

  • $29.99

From the world's most reliable PDB manufacturer comes the Matek F405 F4 Flight Controller. Designed to give you the highest level of performance, along with a clean build, the F405 is built using the best components by one of the best electronics manufacturers. The F405-OSD has a built-in OSD, MicroSD card for blackbox, and up to 32k gyro and 16k PID loop performance. This FC runs on Betaflight and the MatekF405 target (see below for links).

This F4 FC can give you AMAZING builds when paired with the FCHUB-6S PDB, which we also carry here at RaceDayQuads. Using a data ribbon which is safely positioned between the two boards, you can have very few wires running to/from the FC. This makes replacements and building much easier. If the data ribbon is somehow broken, or you want to use a different PDB, you can run wires directly to/from the Matek F405 FC without using the ribbon or the FCHUB-6S PDB at all. 


  • MCU: 168MHz STM32F405
  • IMU: 32K ICM20602 accelerometer/gyro (SPI)
  • Support 32K Gyro update & 16K PID Loop
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • Built in inverter for SBUS input (UART2-RX)
  • PPM/UART Shared: UART2-RX
  • Support SoftSerial on S5 & S6
  • Battery Voltage Sensor: 1:10
  • Currsnt Sensor: No (FCHUB-6S option)
  • BEC 5V & 10V: No (FCHUB-6S option)
  • LDO 3.3V: Max.300mA for Spektrum RX
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes
  • 2x LEDs for FC STATUS (Blue, Red)
  • 6x PWM / DShot outputs without conflict
  • 5x UARTs
  • 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Sginal/GND
  • 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  • 1x Side-press button for BOOT(DFU) mode
  • 1x 16pin bottom mounted FFC Slot for FCHUB-6S connection
  • 36x36mm PCB with 30.5mm mounting holes
  • w/ 1x 0.5mm*16Pin 5cm Flexible Flat Cable
  • w/ 4pcs M3 Anti-vibration Standoffs

We Also Recommend



Sold Out