Stan FPV Cycle 2203 3450Kv Motor - T-Mount

Coming Soon
In Stock
Pre Order
Add to Wishlist
Free Delivery on U.S.A. Orders $50 or more

This unique new motor is the result of a collaboration between Stan FPV & Bob Roogi. The motor delivers power in an entirely new way and will give you some of the the SMOOTHEST FLIGHTS and FOOTAGE you've ever experienced! No bull! 

Bob Roogi thoroughly designed these motors from the ground up with his concept of widening and lowering the motor (pancaking). This provides more torque while providing it in a much smoother manner similar to the effect of a car's flywheel mixed with a stabilizing gyro x4! This wide/low design not only makes your motors look like "DUBS" on a car, but also gives AMAZING PERFORMANCE & FLIGHT FEEL 

The extremely unique design also allows for great surface area heat dissipation and stays much cooler than other motors in the cinewhoop catagory which is a HUGE benefit. This along with the extra smooth torque actually helps make them extremely EFFICIENT on 3s and 4s lipos! 

Check out our Stan FPV Products and our entire selection of motors!


  • 22mm stator diameter, 3mm stator height
  • 12x12mm M2 mounting pattern (not flush mount)
  • 0.15mm Kawasaki High performance laminations
  • N52SH ARC magnets
  • 3mm grade 5 titanium internal shaft C clip retention (much lower weight)
  • T-mount (3 hole) M2 prop mounting 
  • 3x8x4mm 693zz Japan ISC Custom bearings
  • 7075-T6 aluminum casing
  • 260℃ enamel coated single wrap oxygen-free copper windings
  • Bearing saver damping washer under bell/on top of bearing
  • Tuned steel flux ring
  • Weight: 19g with ~150mm length wires
  • Weight: 16g with cut wires


  • 1x Stan FPV Cycle 2203 3450Kv Motor - T-Mount