XHover Skyeliner by Drib 5" Freestyle Frame

$82.95
Coming Soon
In Stock
Pre Order
Add to Wishlist

Le Drib designed his signature frame, the Skyeliner, to be simple in construction, aesthetic in design, and durable in crashing. 

Now includes the Stage 2 Upgrade which reinforces the front end to improve durability. See video below for more information.

The front camera cage was inspired by the look of an airfoil to look attractive. It was shaped around the sweep of the FPV camera angle to provide protection regardless of camera position and the 3D printed GoPro mount was considered from the beginning rather than left to be retro-fitted.

The top plate removes with 5 screws, allowing access to the drone’s internals. The front camera cage stays secure to the main plate even without the top plate so it will not fall out while handling the opened drone.

The overlap between the main plate and arms has an extreme curve to distribute the shear force on the arms during crashes. Should an arm need replacing, press nuts in the main plate facilitate the swap. Additionally, the 30 x 30 holes in the arms and lower brace are enlarged so that the electronics stack need not be disturbed when replacing arms. 

The 30 x 30 holes in the main plate accommodate the included grommets to isolate the electronics stack.

The two slots in the rear of the main plate were designed around a 20x20 M2 hole pattern. A component such as a receiver can be placed between the slots and strapped down while M2 screws can fit in the ends of the slot to mount a an additional 20x20 component such as a video transmitter.

The top plate sits 20mm above the mainplate. He found that he prefers the agile feel of top mount over the neutral feel of mid mount. However, also found that the lowering the battery a bit improved the “locked in” feel. He settled on 20mm as his favorite height of top mount battery.

Check out our 5" frame selection and all our XHover Gear!

Features

  • Soft mount for FC on the 30x30 stack.
  • 20mm Standoffs
  • Ummagrip Sticky Battery Pad
  • Top Mount battery Design
  • 4mm durable arms 
  • Plenty of room for a nice clean compact build
  • Easy single arm replacement 

    Includes

    • 1x Skyeliner Frame
    • 1x Set of high-quality Steel hardware
    • 1x Battery Strap
    • 1x ESC sticker Sheet
    • 4x Foam Landing Pads
    • 1x Sticky Battery pad by Ummagrip Company, Designed specifically for the Skyeliner
    • 1x Stage 2 Upgrade Kit NEW!

    You recently viewed

    Clear recently viewed
    x