ImpulseRC Frames

Looking for a PDB or spare parts? We have them all! Designed from deep inside the "skunkworks" at ImpulseRC, the Alien design has revolutionized th...

Looking for a PDB or spare parts? We have them all! FEATURES Premium 3K plain weave matte finish carbon fibre Gunmetal high-carbon high-tensile s...

7" arm set for the ImpulseRC Slammed Alien 5" FPV Frame 

6" arm set for the ImpulseRC Slammed Alien 5" FPV Frame

5" arm set for the ImpulseRC Slammed Alien 5" FPV Frame

4" arm set for the ImpulseRC Slammed Alien 5" FPV Frame

This is a single spare 7" arm for the Reverb Freestyle frame.

This is a single spare 6" arm for the Reverb Freestyle frame.

This is a single spare 5" arm for the Reverb Freestyle frame.

Our GoPro Session Mount & Protector for the ImpulseRC Reverb is available in our full range of colors and two tilt angles.  The necessary hardw...

PDB Insulator for the Alien 4oz copper PDB kit

PDB for the ImpulseRC Slammed Alien 5" FPV Frame As simple as it looks, this PDB contains 4 ounces of copper - enough to supply even the most power...

Conversion Kit only!  The Alien slammed conversion kit was designed to fit as many micro size cameras as possible. Mini and standard size cameras ...

Spare Body kit for the Slammed Alien by ImpulseRC Please note this is only the main body kit and does not include arms, hardware, or the alien PDB....

Please note these are carbon replacements only! If you are wanting to convert your Alien to a slammed version please purchase our Alien 5" slammed ...

Screw Pack and Hardware Kit for the ImpulseRC Slammed Alien 5" FPV Frame   Includes: (11x) M3x6mm Cap - High Tensile Carbon Steel - Gunmetal (8x) ...

PDB KIT 3oz Copper - 1.6mm PCB Genuine XT-60 with 14AWG Silicon wire 7 Pin JST-GH to solid core Silicon wire (For generic setup) 7 Pin JST-GH to 6...

Introducing the ImpulseRC Wolf PDB Rev 2 *The new Rev2 Wolf PDB has a different pin out to improve grounding and noise isolation*  Designed from ...

FOAM LIPO PAD CONFORMING TO THE REVERB TOP PLATE   4mm thick to protect the lipo from screw heads.

As shown in photos - spare top plate for the Reverb FPV frame.

SPARE LOWER SPLIT MAIN PLATE FOR THE REVERB FPV FRAME  

1.5mm thick - SPARE UPPER SPLIT MAIN PLATE FOR THE REVERB FPV FRAME

SPARE CAMERA SIDE PLATES FOR THE REVERB FPV FRAME - 2 PACK

Honestly I can't justify paying this much for these antenna clamps... I (Tyler, the owner of RDQ) would recommend just taping your antennas to the ...

REVERB FULL SCREW PACK - HIGH TENSILE   (1x) M3x6mm Cap - High Tensile Carbon Steel - Gunmetal (5x) M3x10mm Cap - High Tensile Carbon Steel - Gunm...

Includes a replacement arm for the ImpulseRC Alien 5" frame  - x1

The much anticipated Mr. Steele KISS PDB for the ImpulseRC Alien frame series! Built using Steele's preferred and tested components, and designed t...