(PRE-ORDER) BetaFPV BNF Meteor65 PRO 2022 1S Brushless Analog Whoop - ELRS 2.4GHz

On order and PRE-ORDERS shipping ASAP!!! All products with batteries must be shipped by a ground shipping method.

The Meteor65 Pro comes with a 35mm propeller for power improvement and a flexible flying experience. Beyond that, it has almost the same components and features as Meteor65, like F4 1S 5A FC (2022) with built-in serial ExpressLRS 2.4G, Frsky, or TBS RX version, up to 350mW M03 VTX, 19500KV 0802SE motors, C03 FPV camera, etc, All aspects of performance are perfectly balanced. 

Make sure to check out our other Pre-Built quads and the rest of our BetaFPV selection!

Specifications

• By using the latest 0802SE 19500KV motors and 35mm 3-blade props, this kit provides you with a completely different experience of a powerful indoor flight.
• Built-in 1.52g ultralight weight and upgraded C03 FPV camera. This new camera has optimal performance for indoor whoop drones.
• Adopt with injection molding technique, this canopy is 1.60g ultralight weight and is more durable, anti-ruin, and heat-resistant, providing good protection for the whoop drone.
  
• Reserve two UART ports on F4 1S 5A FC (SPI Frsky) board. The Frsky version also can be used as the PNP version. Therefore, pilots can connect the external receiver to it.
  
• F4 1S 5A FC (Serial ELRS 2.4G) is flexible in upgrading and has great potential. It supports being upgraded to ELRS V3.0 separately without flashing Betaflight flight controller firmware.
  
• The various colors of the spare parts including the 65 Pro 65mm frame, micro canopy, and propellers offer pilots more choices. Using them with BETAFPV waterslide decals, pilots can easily DIY and build their unique whoop drones.

AIO

• CPU: STM32F411CEU6 ( 100MHZ )
• Gyro: ICM-20689/MPU-6000
• Receiver: SPI ExpressLRS 2.4G
• RX Antenna: 2.4GHz SMD ceramic antenna
• Firmware version: betaflight_4.3.0_STM32F411_norevision
• OSD: Built-in BetaFlight OSD
• Input Voltage: 1S
• Max Continuous Current: 5A
• Max Burst Current: 6A
• Support BLHeliSuite: Yes
• Firmware: O_H_5_48_REV16_8.HEX
• Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM

Includes

• 1x Meteor65 Pro Brushless Whoop Quadcopter (1S)
• 2x 300mAh 1S 30C Battery with BT2.0 connector
• 1x BT2.0 Battery Charger and Voltage Tester
• 1x TypeC USB cable
• 1x Customized Carry Case
• 1x Spare 35mm 3-blade props (1.0mm Shaft)
• 1x Screwdriver
• 3x Decorative Parts
• 1x 20° Lens Camera Mount for C03 Camera
• 1x 30° Lens Camera Mount for C02 Camera