Light Bulb Smoke Stopper - XT60
The Light Bulb Smoke Stopper is an old-Fashioned way to test and protect your electronics after hours of building. A carefully chosen light bulb can turn into a great over-current protection device. Connect it between your battery and quad-copter, so only a small amount of current is allowed to pass through, enough to illuminate the bulb but no more. It saves your electronic components from current surges, and gives you a chance to troubleshoot the failure without having to replace the burnt-out parts.
Be sure to check out our tools & building supplies!
- Bulb: 3157 Automotive Bulb
- Wire: 14 Gauge
- Connector: XT60 male and female
- Input: 1S to 6S Batteries
- 1x Light Bulb Smoke Stopper - XT60
How it works:
-First plug it in.
-If there is no short circuit the bulb will dimly light up and all electronics will initialize normally.
-If there is a short circuit the bulb will light up very bright to limit the current that gets to the electronics.
**The brightness of the bulb will depend on input voltage**
Note: Solid State Smoke Inhibitor/ Lightbulbs / Fuses / Circuit breakers are not 100% foolproof way of keeping the magic smoke in. It’s always best to use in conjunction with a multimeter. This is NOT an end all be all kind of protection. Nothing is. It is best at protecting against a soldering short. If you wire something wrong, it will likely still blow (ie apply 16v to a 5v system). This is a failsafe, one that will probably help you but may not depending on the kind of error you make. Double check wiring schematics, check your gear with a multimeter, and lastly use a Smoke Stopper. Do not wire things up randomly and hope a Smoke Stopper will save you - that's a bold move Cotton!
Check out our other smokes stoppers in XT60 and XT30.