Hot Products

Another Express LRS receiver but this time, it's PWM capable! The Happymodel ExpressLRS PWM Kit includes a 6CH EPW6 2.4GHz Receiver with two antenn...

Introducing the HappyModel Bassline 2S Micro FPV Racer Drone! This high-performance drone is perfect for FPV racing and freestyle flying. With its ...

HappyModel ES900 DUAL RX ELRS Diversity Receiver 915MHz / 868MHz Built-in TCXO for RC Airplane FPV Long Range Drones.  Check out the rest of our EL...

Classic 0802 stator rated to be capable of 20,000Kv for major power, a good sweet spot for high Kv motors, where you get that extreme power without...

The ES24TX Pro Micro ExpressLRS TX module is a upgrade version of ES24TX module.Max output up to 1000mw, reserved Cooling Fan and RGB LED module. T...

This Slim Pro TX module is designed by Happymodel and based on the open-source  ExpressLRS which is a very popular low latency and high packet rate...

Gemfan's new 1.6" (40mm) bi-blades are a direct replacement for the HappyModel Mobeetle or the Happymodel 1S Mobula 7 but also work well on all qua...

Make your drone projects even better with this HappyModel SE0702 0702 28000Kv Micro Motor. Its high-quality design offers efficient oper...

This is a replacement bottom plate for the Crux35 and Crux35 HD frames. Check out our other Crux35 accessories, as well as our entire Happymodel se...

The Happymodel EP2 TCXO RX is a nano-sized true diversity 2.4GHz ELRS receiver with RF amps. This TCXO Rx receiver uses a temperature-compensated c...

The Happymodel EX1002 is a 1002 brushless motor with 20000KV. This is a replacement motor for the Happymodel 1S HDZero Whoop. Check out the rest of...

This is a replacement frame for the Crux 35 Frame. Check out our other Crux35 accessories, as well as the rest of our HappyModel selection! Specifi...

This set of 4 EX 1102 13500 Kv brushless motors with 1.5mm shaft are replacements motor for the Happymodel Mobula7 HD brushless cinewhoop, but can ...

HappyModel has been making micro motors for a long time, and their experience shows in this EX line of motors. Check out our other 1404 motors, and...

Spare replacement Flight Controller for the Happymodel Mobula 6, and an all around incredible little TRUE AIO for any 1S brushless build!  Check ou...

The Happymodel SE0802 19000KV are the direct replacement motors for the Mobula 6 HD 1S, so RDQ has you covered! It will also work great on racing w...

Turn your Mobula7 from amazing to amazingly tough! Happymodel has redesigned the Mobula7 frame, making it more rigid and durable and adding some ne...

This 5-in-1 flight controller is inspired by Happymodel's Official Pilot - Angry Don FPV! The Happymodel Diamond F4 AIO 5-IN-1 Flight controller ha...

The four HappyModel SE0802 16000Kv 1-2S Whoop/Micro Motor for Mobula7 4 Pack is just what you need. These are made for the Mobula7 micro drone but ...

All batteries must be shipped by a ground shipping method. Spare battery for the HappyModel Moblite7 Whoop. Check out the entire RDQ Series of LiPo...

This antenna is a perfect replacement for the ERLS or TBS Tracer receivers.  Check out the rest of our ELRS accessories, as well as the rest of our...

This antenna is a perfect replacement for the ERLS or TBS Tracer receivers.  Check out the rest of our ELRS accessories, as well as the rest of our...

The ideal antenna for your Express LRS Module! Designed specifically for the Happy Model ES24TX but will work on any module with SMA connector and ...

Rubber Damping Balls and Screw Set for Mobula7 Crazybee F3 F4 flight controller The short rubber damping ball is used for the front, the long rubbe...

The T-Antenna is an omnidirectional antenna. It is intended for short to medium ranges and is suitable for most conditions. Check out all our RC Tr...

Introducing the Moblite7 Ultralight FPV Brushless Whoop! Made in collaboration with FPV pilot "Mr. Shutterbug," this whoop is one of the lightest 7...

The Happymodel 1S Balance Charging Board allows you to charge up to four 1S LiPo batteries with PH2 connector at the same time. The board supports ...

The world's first AIO 5in1 whoop flight controller with built-in ExpressLRS receiver is coming out now. This F4 flight controller has a built-in 5A...

Can be used for any build and a perfect replacement part for the HappyModel Crux3 Check out the our other motors as well as our HappyModel Crux3 Qu...

4 Hole versionIndividual spare replacement motors for the HappyModel Larva X & SailFly. Check out all our micro motors and our HappyModel gear!...

It's finally here! The ultralight 1s 5a AIO of the future comes in at a clean 2.8g. This is the AIO that got the mobula6 HDZero whoop under 25 gram...

Spare replacement Canopy for the HappyModel Larva X. Check out the rest of our Larva X parts, and all our HappyModel gear! Includes 1x HappyModel ...

The X12 lite does away with the onboard VTX, shedding weight and giving you the option to add your own VTX. It also comes with an onboard ELR...

The Happymodel OVX303 VTX is based on the Open source project OpenVTX powered by Jye Smith from the EpxressLRS team. Open VTX aims to provide firmw...

The Happymodel OVX300 VTX is based on the Open source project OpenVTX powered by JyeSmith from the EpxressLRS team. Open VTX aims to provide firmwa...