HolyBro Kakute F7 AIO V1.5 30x30 Flight Controller

$48.99
In Stock
Pre Order
Coming Soon
Free Delivery on U.S.A. Orders $50 or more
Add to Wishlist

A great option for those running individual ESCs who want a full featured F7 Flight Controller.

Check out all our 30x30 Flight Controllers and all our Holybro Products!

Features

  • Supports Betaflight, Butterflight.
  • Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and power level, all using your transmitter sticks and goggles.
  • Soft-mounting built in. The IMU (“gyro”) chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
  • High-performance / low-noise / high sensitivity IMU. MPU6000 with 6-axis gyro and accelerometer. 
  • Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with external GPS/magnetometer units.
  • 2 oz. copper PCB allows up to 120A maximum continuous current.
  • Dedicated bootloader button for easy firmware flashing.
  • Low-profile design fits into even very compact frames.
  • Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only).
  • Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the Kakute F7 AIO monitors voltage directly from the battery power lead.
  • Filtered voltage output for clean, noise-free video. On-board regulators output 5v at up to 2 amps and 3.3v at up to 200 mA to power peripherals such as receiver, video transmitter, FPV camera, or LED strip.
  • Supports BLHeli pass-through for easy ESC upgrade and configuration.

    Specifications

     

    • MCU: STM32F745 32-bit processor
    • IMU: MPU6000 (SPI)
    • Barometer: BMP280
    • Current Sensor: Approximately 130 amps maximum measurable value
    • USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
    • 6 hardware UARTS (UART1,2,3,4,6,7)
    • All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”.
    • Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
    • TF card for Blackbox logging
    • Dimensions: 35x48x7mm (includes foam-mounted gyro board in height)
    • Mounting Holes: Standard 30.5mm square to center of holes 
    • Weight: 11.2g

      Includes

      • 1x HolyBro Kakute F7 AIO V1.5 30x30 Flight Controller

      Manual

      x