Matek F722 HD 30x30 Flight Controller for DJI

In Stock
Pre Order
Coming Soon
Add to Wishlist
Free Delivery on U.S.A. Orders $50 or more

iNav and Betaflight compatible and packed with features, especially suited for long range builds.

Check out all our 30x30 FCs as well as the entire Matek selection!


  • STM32F722
  • MPU6000
  • BMP280
  • 32M flash Blackbox
  • 10x PWM outputs
  • 6x UARTs, I2C
  • Dual BEC
  • 3~8S supported
  • DJI FPV OSD supported


  • MCU: 216MHz STM32F722RET6
  • IMU: MPU6000 (SPI)
  • Baro: BMP280 (I2C)
  • Blackbox: 32M-byte Flash memory (SPI)
  • OSD: Support external DJI OSD/FrskyOSD, No Analog MAX7456 OSD built-in
  • 6x Uarts with built-in inversion
  • 1x Softserial_Tx option
  • 10x Dshot/PWM outputs
  • 1x I2C
  • 4x ADC (VBAT, Current, RSSI, AirSpeed)
  • 2x SH1.0_8pin connector (Vbat/G/Curr/Rx3/S1~S10)
  • 1x SH1.0_6pin connector for DJI FPV Air Unit
  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • Switchable 8V output
  • PWM camera control: Yes
  • TR/SA VTX control: Yes
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes
  • Analog Airspeed sensor: Yes
  • Digital Airspeed sensor: Yes
  • Input: 9~36V (3~8S LiPo)
  • BEC: 5V 2A cont. (Max.3A)
  • BEC: 8V 2A cont. (Max.3A)
  • LDO 3.3V: Max.200mA
  • Battery Voltage Sensor: 1:10 (Scale 110)
  • No Current Sensor built-in
  • FC Firmware
  • BetaFlight unified target: MATEKF722HD(MTKS)
  • INAV target: MATEKF722PX
  • Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
  • Dimensions: 36 x 36 x 5 mm
  • Weight: 6.5g


  • 1x Matek F722 HD 30x30 Flight Controller for DJI

F722-HD Quick Start Guide

  • BetaFlight unified target MATEKF722HD , or download betaflight firmware from HERE
  • Select “MATEKF722HD” in pull-down list of BetaFlight configurator when you flashing it.
  • In BetaFlight CLI mode, type   ” resource SERIAL_TX 11 A02 ” if you want to use TX2 pad as softserial1_TX.
  • If using FrskyOSD module,  enable FrskyOSD on Uart6 in BF configurator 10.7 or latest.


  • INAV target MATEKF722PX
  • INAV firmware has FrskyOSD enabled on Uart6 by default,  replace it with “DJI FPV VTX” protocol.